Remcon 12 Rx schematic needed
Posted: 14 Sep 2018, 02:50
Don't ask me why I try to fix this stuff, especially old reed sets from the UK, but I get what I deserve by trying....a BIG headache!
I have a REMCON 12 receiver with a dead audio stage, very low (.5V peak to peak ) audio signal and so I need a schematic to figure out the circuit, and what types of transistors are used, and the electrolytic cap values.
I see it has Jap transistors, which are very hard to source here, as they were never popular and nobody ever carried a good stock of them at the retail level. Hopefully I can use a general purpose silicon transistor to substitute if the original is bad, but I need a schematic 1st. Of course now I'm really getting hopeful and would like a component layout, but that is probably a pipe dream!
Any help is appreciated lads,
thanks in advance,
Jay
I have a REMCON 12 receiver with a dead audio stage, very low (.5V peak to peak ) audio signal and so I need a schematic to figure out the circuit, and what types of transistors are used, and the electrolytic cap values.
I see it has Jap transistors, which are very hard to source here, as they were never popular and nobody ever carried a good stock of them at the retail level. Hopefully I can use a general purpose silicon transistor to substitute if the original is bad, but I need a schematic 1st. Of course now I'm really getting hopeful and would like a component layout, but that is probably a pipe dream!
Any help is appreciated lads,
thanks in advance,
Jay