Page 1 of 1

Reset on ATtiny85

Posted: 04 Aug 2019, 09:33
by MaxZ
I am setting up an ATtiny85 as a servo reverser, using Vero strip board to connect the wires. Because of the layout it would suit me best to connect the reset pin to Vcc (after programming of course). Is there any detrimental effect in doing so? An alternative would be to cut the pin short and not solder it to the board.

Cheers,
Max.

Re: Reset on ATtiny85

Posted: 04 Aug 2019, 09:56
by Phil_G
Yes that will be fine Max