Page 1 of 1
HB stick units
Posted: 01 Mar 2018, 07:52
by chlluk
Hi
I'm scaling an image of a PCB for manufacture and the only known detail I have is the 4 board fixing screws.
It mounts on the back of a HB stick unit. Anyone Know the centre distances of these holes?
Clive
Re: HB stick units
Posted: 02 Mar 2018, 23:59
by Shaun
Which pcb Clive - is it the stick mounted GG pulser from RCM&E?
Cheers
Shaun
Re: HB stick units
Posted: 03 Mar 2018, 18:51
by chlluk
That's the one
Clive
Re: HB stick units
Posted: 07 Mar 2018, 17:48
by Shaun
Here you go Clive . Mounting hole centers (vertical and horizontal) are 1 3/4". I didn't mount mine on the back of the stick unit as shown in the article. As I used and old MacGregor 2 channel single stick case, I just mounted the board to the tx case..
Mine worked fine..
Shaun
Re: HB stick units
Posted: 07 Mar 2018, 18:07
by Shaun
And don't forget they printed some corrections in the Jan RCM&E.
Shaun
Re: HB stick units
Posted: 07 Mar 2018, 18:40
by Shaun
Here's a few pics of the Radio Modeller GG set I built a few years ago.. This one works fine as well..
Case was from Maplins.. good job I bought a few of them
Shaun
Re: HB stick units
Posted: 07 Mar 2018, 20:59
by chlluk
Many thanks Shaun,I now have my low cost proportional book, got a copy from Australia.
Re: HB stick units
Posted: 07 Mar 2018, 21:28
by Shaun
Which edition is it Clive as there were a few edits released after the first copy was published.
Shaun