Technical question please. Due to physical problems I fly WITH a Futaba FF8 converted to single stick and a slide throttle on the right hand side of the case that I move with the little finger while twiddling the stick. I find it quite difficult to move the slide switch up and down while my older JR cuddle box with a horizontally mounted throttle, which I believe is an adapted trim, is much easier to use. I would like to change my FF8 to a horizontal throttle but the case is not deep enough. So i was wondering if any one knows of a rotary control that I could replace the slide with. the full servo/ throttle movement would have to be in 90-100 degrees of rotation of the switch.
Any and all advice from where such a control could be sourced will be gratefully received.
Thanks, Steve.
Futaba FF8
- Wayne_H
- Posts: 811
- Joined: 17 Feb 2018, 05:26
- Location: Temora, NSW. Australia
- Contact:
Re: Futaba FF8
Hi Steve,
Any chance of a few pictures? - what configuration works (JR) & what doesn't (FF8). I have some old (but unused) Multiplex linear slide pots which are very shallow (thin?), so may be a viable option.
Any chance of a few pictures? - what configuration works (JR) & what doesn't (FF8). I have some old (but unused) Multiplex linear slide pots which are very shallow (thin?), so may be a viable option.
Cheers,
Wayne
Once a Retrobate, always a Retrobate............
Wayne
Once a Retrobate, always a Retrobate............
-
- Posts: 165
- Joined: 04 Feb 2019, 22:07
- Location: Nth Somerset
Re: Futaba FF8
Steve, Not the answer to your question, but I saw this and thought of you... looks like it would take a 2.4gHz RF module.
https://www.ebay.co.uk/itm/Futaba-FP-T8 ... 1438.l2649
https://www.ebay.co.uk/itm/Futaba-FP-T8 ... 1438.l2649
"I'm your huckleberry, that's just my game"
-
- Posts: 91
- Joined: 03 Mar 2018, 10:08
Re: Futaba FF8
Unfortunately those sets radios are PCM only so are no good for a 2.4 Module, however a friend has given me a JR PCM 9 that has a very neat rotary control set in the top right hand corner, , hopefully I can swap the throttle pot wire to this control. I will use this on 3 function models with the aim of adding a rotary rudder control to the stick later. the set will switch from PCM to PPM and takes a 2.4 module, proper job!!
-
- Posts: 745
- Joined: 16 Feb 2018, 14:11
- Location: Warwickshire
Re: Futaba FF8
I don't think the ff8 was pcm only. The ff6, ff7, ff8, and ff9 could all do ppm or pcm.
- Sundancer
- Posts: 122
- Joined: 07 Jun 2018, 09:28
- Location: Limousin, France
Re: Futaba FF8
That is correct; I have two FF8s, one of whch is converted to 2.4 gig. They were PPM/PCM.
- Shaun
- Posts: 1057
- Joined: 15 Feb 2018, 21:49
- Location: West Yorkshire
Re: Futaba FF8
My first set coverted was a ff8 with a Corona 2.4g module..worked a treat.
Shaun.
Shaun.