I feel very lucky to receive Phil's Blunderbird via Shaun - thank you both. Built by Tobe, and very nicely built it is too.
As the subject title suggests it's a glider, in fact it will be a slope soarer
I've done a few jobs on it. One that's not visible is to glue in 1/16" ply doublers and bottom to the inside or the nose area. There were no doublers, so thought it a good idea. So the 35Mhz receiver and 4 AA cell battery pack are up front - I chose the biggest receiver and used AA cells simply for weight to balance the model - just 3 additional two pence coins gave the correct balance.
The other jobs are shown in the pictures:
I have done a few test glides and it has a fantastic glide I'll upload a couple of short video clips later.
Carl
Blunderbird 1
- Carl
- Posts: 267
- Joined: 16 Feb 2018, 13:26
- Location: Way down in the South West
- Contact:
Blunderbird 1
Carl
------------------------------------
STILL LEARNING
------------------------------------
------------------------------------
STILL LEARNING
------------------------------------
- Carl
- Posts: 267
- Joined: 16 Feb 2018, 13:26
- Location: Way down in the South West
- Contact:
Re: Blunderbird 1
I've PM'd this to Phil but it looks as though it doesn't allow jpg attachments. In the previous post I said I will be enlarging the rudder. The picture below shows a red line where I'm proposing to cut the fin to create the larger rudder - it effectively doubles the rudder size.
Does this look like a good place? Bigger still or not so big?
Thanks,
Carl
Does this look like a good place? Bigger still or not so big?
Thanks,
Carl
Carl
------------------------------------
STILL LEARNING
------------------------------------
------------------------------------
STILL LEARNING
------------------------------------
- Carl
- Posts: 267
- Joined: 16 Feb 2018, 13:26
- Location: Way down in the South West
- Contact:
Re: Blunderbird 1
Forgot to mention earlier the AUW came out at a little under 13oz, and because the wing area works out approx 144 sq.in the wing loading is a little under 13 oz/sq.ft.
I've uploaded a video clip on YouTube that shows a test glide that almost went wrong Prior to this I'd done a test glide and it glided nicely into the thick green bushy stuff in the grass. So I did another glide with a firmer push and it picked up some lift and off it went - but I hadn't yet plugged in the battery as I was intending it to land in the grass again
So just stood and watched it float of towards the coast, but as it glided down into the little valley it picked up the off shore breeze and turned to glide along the bottom. Amazingly it carried on gliding and just as it touched down it nudged a surprised sheep
So the test glide turned into a 30sec FF glide
Carl
I've uploaded a video clip on YouTube that shows a test glide that almost went wrong Prior to this I'd done a test glide and it glided nicely into the thick green bushy stuff in the grass. So I did another glide with a firmer push and it picked up some lift and off it went - but I hadn't yet plugged in the battery as I was intending it to land in the grass again
So just stood and watched it float of towards the coast, but as it glided down into the little valley it picked up the off shore breeze and turned to glide along the bottom. Amazingly it carried on gliding and just as it touched down it nudged a surprised sheep
So the test glide turned into a 30sec FF glide
Carl
Carl
------------------------------------
STILL LEARNING
------------------------------------
------------------------------------
STILL LEARNING
------------------------------------
- Wayne_H
- Posts: 811
- Joined: 17 Feb 2018, 05:26
- Location: Temora, NSW. Australia
- Contact:
Re: Blunderbird 1
Well I never........ A Kiwi Blunderbird - what ever will they think of next?
Cheers,
Wayne
Once a Retrobate, always a Retrobate............
Wayne
Once a Retrobate, always a Retrobate............
-
- Posts: 284
- Joined: 15 Feb 2018, 23:12
Re: Blunderbird 1
.....and not to mention the Canning stock root....(or is that route? I can never remember)
Only Aussies will get it....
Gary
Only Aussies will get it....
Gary
- Carl
- Posts: 267
- Joined: 16 Feb 2018, 13:26
- Location: Way down in the South West
- Contact:
Re: Blunderbird 1
So I've enlarged the rudder on the Blunderbird - gone half way between what I previously suggested and the original hinge point. Here's a link to a video clip of the rudder movement showing quite a lot of throw. Being a beginner I'm quite happy to receive an opinion. I could reduce using rates or move the wire loop on the rudder back down to the original position. The servo is a little buzzy but works perfectly well.
Carl
Carl
Carl
------------------------------------
STILL LEARNING
------------------------------------
------------------------------------
STILL LEARNING
------------------------------------
-
- Posts: 21
- Joined: 21 Feb 2018, 02:01
- Location: North Carolina
Re: Blunderbird 1
At least on your video, the torque rod looks in danger of popping out of the yoke when hard over, or do my eyes deceive me?
- Carl
- Posts: 267
- Joined: 16 Feb 2018, 13:26
- Location: Way down in the South West
- Contact:
Re: Blunderbird 1
It is close, but I'm going to move the yoke back down to the original position anyway for the time being whilst gaining experience.pulserudder wrote: ↑14 Jul 2018, 20:42 At least on your video, the torque rod looks in danger of popping out of the yoke when hard over, or do my eyes deceive me?
Carl
Carl
------------------------------------
STILL LEARNING
------------------------------------
------------------------------------
STILL LEARNING
------------------------------------
- Wayne_H
- Posts: 811
- Joined: 17 Feb 2018, 05:26
- Location: Temora, NSW. Australia
- Contact:
Re: Blunderbird 1
Carl,
Is your bird blundering along the slope yet ??
Is your bird blundering along the slope yet ??
Cheers,
Wayne
Once a Retrobate, always a Retrobate............
Wayne
Once a Retrobate, always a Retrobate............
- Carl
- Posts: 267
- Joined: 16 Feb 2018, 13:26
- Location: Way down in the South West
- Contact:
Re: Blunderbird 1
Not yet Wayne. I've taken it with me each time I go out flying, but barely a breeze so not tried it other than test glide - has a very nice glide
Carl
Carl
------------------------------------
STILL LEARNING
------------------------------------
------------------------------------
STILL LEARNING
------------------------------------