Kraft Comander
-
- Posts: 2
- Joined: 25 Oct 2020, 07:51
Kraft Comander
I have a FrSky module, received from a friend I want to build in my Kraft Commander single channel now I have programmed an Aduino, who can help me with the connection data of the FrSky V8FT, I am looking for the pins for power and PPM signal.
-
- Posts: 4
- Joined: 27 Mar 2018, 17:29
-
- Posts: 81
- Joined: 12 Jun 2018, 15:22
- Location: Ontario Canada
Re: Kraft Comander
JanW Try posting your question in the Help section under the Welcome banner.
I know less than nothing about Arduino, but would be surprised if the pin out was the same as Futaba. The Futaba pin info out was VERY useful to me for an upcoming project however!
Good luck with your Kraft Commander upgrade. I have an earlier ACE Commander conversion I have been using for a few years.
Mike F
I know less than nothing about Arduino, but would be surprised if the pin out was the same as Futaba. The Futaba pin info out was VERY useful to me for an upcoming project however!
Good luck with your Kraft Commander upgrade. I have an earlier ACE Commander conversion I have been using for a few years.
Mike F