One of the New Bunch
Posted: 20 Sep 2020, 11:36
Hidehi,
Recently “activated”, I’m not exactly a newbie, more “new old stock”, round here. I can remember two-valve transmitters, 90V HT batteries, 8’ 6” aerials and George Honest-Redlich.
My successful r/c flying only commenced circa ‘74, with a Macgregor propo set, in a Graupner Dandy, up on Ivinghoe Beacon. I remain a Graupner glider geek to this day.
Part of my r/c apprenticeship included, in early 1968, building a Remcon 12 Versatile kit. It worked! I got the reeds humming nicely and was about to turn my attention to adding transistor amplifiers to a brace of Bonner Duramites, when the transmitter got nicked from my car. The project never got finished ....... until now!
Encouraged by Phil-G and the M48 Construction Booklet (now including the missing page 8), over on the Single Channel website, I’m building another transmitter from scratch. I’ve found all the transistors, and been converted to cheap laser pcb production, over etch-resist pen.
However, if I may, I will need a 27Meg loaded aerial and a pair of matched crystals (465 separation, with leads, not pins). If anyone has same for sale - or any redundant Remcon 12 bits, following conversion to 2.4Gig, I would appreciate a PM.
With thanks and best wishes,
John
West Midlands
Recently “activated”, I’m not exactly a newbie, more “new old stock”, round here. I can remember two-valve transmitters, 90V HT batteries, 8’ 6” aerials and George Honest-Redlich.
My successful r/c flying only commenced circa ‘74, with a Macgregor propo set, in a Graupner Dandy, up on Ivinghoe Beacon. I remain a Graupner glider geek to this day.
Part of my r/c apprenticeship included, in early 1968, building a Remcon 12 Versatile kit. It worked! I got the reeds humming nicely and was about to turn my attention to adding transistor amplifiers to a brace of Bonner Duramites, when the transmitter got nicked from my car. The project never got finished ....... until now!
Encouraged by Phil-G and the M48 Construction Booklet (now including the missing page 8), over on the Single Channel website, I’m building another transmitter from scratch. I’ve found all the transistors, and been converted to cheap laser pcb production, over etch-resist pen.
However, if I may, I will need a 27Meg loaded aerial and a pair of matched crystals (465 separation, with leads, not pins). If anyone has same for sale - or any redundant Remcon 12 bits, following conversion to 2.4Gig, I would appreciate a PM.
With thanks and best wishes,
John
West Midlands