Right, in the absence of any reactions on this post in the FlySky RM-FS0002 topic, and on a similar question in the Dutch forum, I am still stuck acquiring a module with AFHDS protocol. So I decided to butcher the pistol grip Tx after all. I had to desolder the antenna, which is quite tricky, so hopefully I can get it soldered on again without failure.MaxZ wrote: ↑25 Jan 2020, 18:15 Hi,
Does anyone know if and where I could buy a FlySky FS-RM0002 module? I have a bunch of HK GT2R 3 channel receivers operated with the AFHDS protocol, and a cheap pistol grip Tx, and I want to convert an old Robbe 2 channel Tx to 2.4 GHz. ( no Phil, not the same one ) I looked into butchering the pistol grip Tx and extract the HF board, but it is intimately mated with the main board, and the connections are not identified afa. I can see.
Cheers,
Max.
The salvaged module appears to run on 5V, and as my supply is a 2s lipo, I need to install a regulator of sorts. Would it be possible to tap the regulated supply of the DigiSpark board, or would that be over-stressing the regulator?
Cheers,
Max.